Strain gauge transducer amplifier
High environmental protection
Voltage / 4-20mA output
Simple trimpot controls
Signal conditioning is required where the output of a transducer needs to be boosted or changed into a form suitable for the monitor or logging device which will be used. These amplifiers are suitable for strain gauge sensors and some internally amplified transducers.
Our S7 amplifiers are specifically designed to be installed close to the transducer so that the signal can be boosted as soon as possible. The S7 signal conditioning units are mounted in a die-cast aluminium housing and have a good level of environmental protection and screening from electrical noise.
Our S7 amplifiers are specifically designed to be installed close to the transducer so that the signal can be boosted as soon as possible. The S7 signal conditioning units are mounted in a die-cast aluminium housing and have a good level of environmental protection and screening from electrical noise.
A=220mm
B=204mm
C=120mm
D=82mm
E=81mm
F=6mm
Cable gland cable size (x1) = 5mm to 9mm
Cable gland cable size (x2) = 3.0mm to 6.5mm
Compatible with most full bridge strain gauge transducers
Specification